Kia Soul: Mode selection
The mode selection button controls the direction of the air flow through the ventilation system.
Refer to the illustration in the “Manual climate control system”.
The air flow outlet port is converted as follows:
Vent mode (B, D)
Air flow is directed toward the upper body and face. Additionally, each outlet can be controlled to direct the air discharged from the outlet.
Vent-Floor mode (B, D, C, E)
Air flow is discharged towards the face and floor.
Floor mode (C, E, A, D)
Most of the air flow is directed to the floor, with a small amount of the air being directed to the windshield and side window defroster.
Floor/Defrost mode (A, C, E, D)
Most of the air flow is directed to the floor and the windshield with a small amount directed to the side window defrosters.
Defrost mode (A, D)
Most of the air flow is directed to the windshield with a small amount of air directed to the side window defrosters.
Instrument panel vents
The outlet port can be opened or closed separately using the thumbwheel.
Also, you can adjust the direction of air delivered from these vents using the vent control lever as shown.
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. Wh ...Temperature control
The temperature will increase to the maximum (HI) by pushing the button (). The temperature will decrease to the minimum (Lo) by pushing the button (). When turning the knob, the temperature will ...See also:
30,000 miles or 24 months
❑ Inspect air conditioning compressor, air conditioner refrigerant and performance
(if equipped)
❑ Inspect cooling system *1
❑ Inspect drive shaft and boots
❑ Inspect ...
Brake discs, pads, calipers and rotors
Check the pads for excessive wear, discs for run out and wear, and calipers for
fluid leakage.
For more information on checking the pads or lining wear limit, we recommend
you to refer to the Kia ...
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform
troubleshooting in accord ...