Kia Soul: Knock Sensor (KS). Knock Sensor (KS). - Engine Control System - Engine Control / Fuel SystemKia Soul: Knock Sensor (KS). Knock Sensor (KS).

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS). Knock Sensor (KS).

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.
Disconnect the knock sensor connector (A).
4.
Remove the mounting bolt (A), and then remove the sensor (B) from the cylinder block.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Knock sensor mounting bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)
    Knock Sensor (KS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    See also:

    Tire chains
    Tire chains, if necessary, should be installed on the front wheels. Be sure that the chains are installed in accordance with the manufacturer's instructions. To minimize tire and chain wear, do ...

    Fuel Economy
    Range (1) The range to empty is the estimated distance the vehicle can be driven with the remaining fuel. - Distance range : 30 ~ 1999 mi or 50 ~ 1999 km. If the estimated distance is below 3 ...

    Rear Torsion Beam Axle Components
    1. Rear torsion beam axle ...