Kia Soul: Installation - Clutch Cover And Disc - Clutch SystemKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Clutch System / Clutch Cover And Disc / Installation

  
If reinstalling used cover, the cover should be installed with its clutch disc as a set.
1.
Apply grease on a disc spline part and transaxle input shaft spline part as required.
Specified grease: CASMOLY L9508
Amount: 0.2 g
  
Possible problems when not following
•
When not applying: Excessive wear of splines and bad clutch operation can occur.
•
When excessively applying: Grease can be scattered by centrifugal force which can contaminate the clutch disc. This can cause a loss of friction force causing a slip.
2.
Install the clutch disc and the cover with SST (A: 09411-1P000).
  
•
When installing the cover, remove the foreign of material of flywheel and pressure plate completely.
•
Make sure about the direction of the clutch disc when installing.
-
Gasoline 2.0: The 'FLYWHEEL SIDE' marked surface should face the flywheel.
-
Gasoline 1.6: The 'T/M SIDE' marked surface should face the transaxle.

3.
Install the clutch cover bolts. Not to be bent or twisted, Tighten them in diagonal directions.
Tightening torque:
Gasoline 1.6 : 14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
Gasoline 2.0 : 11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
  
•
Loosely tighten every clutch cover bolts, then torque to specifications in a diagonal direction. This can prevent twisting, vibration of the cover, and the lifting of the pressure plate.
•
Install the all the components with the specified torques. If not, the clutch torque transaxle may have concerns or the mounting bolt can loosen.
[Gasoline 1.6]

[Gasoline 2.0]
4.
Install the transaxle assembly.
G 1.6 GDI (Refer to Manual Transaxle System - " Manual Transaxle")
G 2.0 GDI (Refer to Manual Transaxle System - " Manual Transaxle")
    Inspection
    Clutch cover assembly 1. Check the diaphragm spring end for wear and uneven height. 2. Check the pressure plate surface for we ...

    Ignition Lock Switch
    ...

    See also:

    Front Body
    Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in th ...

    Answering Calls
    Answering a Call Answering a call with a Bluetooth® Wireless Technology device connected will display the following screen. To accept the call, press key on the steering wheel while the call ...

    Folding the outside rearview mirror
    Manual type (if equipped) To fold the outside rearview mirror, grasp the housing of the mirror and then fold it toward the rear of the vehicle. Electric type (if equipped) To fold the outside ...