Kia Soul: Inspection
Clutch cover assembly |
1. |
Check the diaphragm spring end for wear and uneven height.
|
2. |
Check the pressure plate surface for wear, cracks and color change.
|
3. |
Check the rivets for looseness and replace the clutch cover assembly
if necessary.
|
Clutch disc assembly |
1. |
Check the clutch facing for loose rivets, uneven contact, deterioration
due to seizure, adhesion of oil, or grease, and replace the clutch disc
if defective.
|
2. |
Check for the torsion spring play and damage and if defective,
replace the clutch disc.
|
3. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Removal
1. Remove the transaxle assembly. G 1.6 GDI (Refer to Manual Transaxle System - " Manual Transaxle") G 2.0 GDI (Refer to Manual Transaxle System - &qu ...Installation
If reinstalling used cover, the cover should be installed with its clutch disc as a set. 1 ...See also:
Battery Sensor Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation
bolt:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 l ...
Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions
only for the maintenance items that are easy to perform.
As explained earlier in this section, several procedu ...
Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience. The light will go off after about 30 seconds when the door
is closed. ...