Kia Soul: Heated Oxygen Sensor (HO2S). Repair procedures
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the HO2S connector.
|
3. |
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
|
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
5. |
Check that the resistance is within the specification.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the connector (A), and then remove the sensor (B).
[Bank 1 / Sensor 1]
[Bank 1 / Sensor 2]
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...Rail Pressure Sensor (RPS). Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built ...See also:
Component Location
1. Windshield deicer relay (Built-in ICM relay box)
2. Windshield deicer switch (FATC type)
3. Windshield deicer switch (Manual type)
4. Windshield deiecr
5. ...
Auto stop
To stop the engine in idle stop mode
Stop the vehicle completely by pressing the brake pedal.
You must reach a speed of at least 5 mph (8 km/h) since last idle stop.
The engine will stop and th ...
Dynamic Damper Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...