Kia Soul: Head Lamps Replacement
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the dust cap (A).
|
4. |
Remove the ignitor clip (A) from the lamp assembly after loosening
the mounting screws.
|
5. |
Remove the ignitor and bulb (A).
|
6. |
Disconnect the ignitor connector (A).
|
7. |
Installation is the reverse of removal.
|
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the dust cap (A).
|
4. |
Remove the sockect (A) from the head lamp assembly.
|
5. |
Remove the bulb (A) from the connector.
|
6. |
Installation is the reverse of removal.
|
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the dust cap (A).
|
4. |
Disconnect the connector (A) from the bulb.
|
5. |
Separate the fixed clip (A).
|
6. |
Remove the head lamp high beam bulb (A).
|
7. |
Installation is the reverse of removal.
|
1. |
Turn the head lamp switch off.
|
2. |
Remove the bulb socket (A) and bulb (B) from the lamp assembly.
|
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the head lamp assembly.
|
4. |
Remove the ballast (A) after loosening the screws.
|
5. |
Disconnect the connectors (A) from the ballast.
|
6. |
Installation is the reverse of removal.
|
Head Lamps Installation
1. Install the head lamp bulbs. 2. Reassemble the head lamp bulb covers. 3. Reassembl ...Head Lamp Aiming Instructions
The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions. ...See also:
If the engine stalls while driving
1.Reduce your speed gradually, keeping a straight line. Move cautiously off the
road to a safe place.
2.Turn on your emergency flashers.
3.Try to start the engine again. If your vehicle will not s ...
Inspection
1.
Disconnect the ignition switch connector (B) and key warning
switch connector (A) from under the steering column.
...
Rear Seat Belt Retractor Replacement
•
When installing the belt, make sure not to damage the
retractor.
...