Kia Soul: Fuel Tank Pressure Sensor (FTPS). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS). Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the rear seat cushion.

3.	Remove the fuel pump service cover (A).

4.	Disconnect the fuel tank pressure sensor connector (A).

5.	Remove the fuel tank pressure sensor (B) after releasing the hooks vertically.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

1.	Install in the reverse order of removal.

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Injector. Description and Operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling a ...

Kia Soul: Fuel Tank Pressure Sensor (FTPS). Repair procedures

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams

Injector. Description and Operation

See also:

Categories