Kia Soul: Front Impact Sensor (FIS). Installation - SRSCM - RestraintKia Soul: Front Impact Sensor (FIS). Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Installation

  
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor (B) mounting bolt.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

3.
Connect the front impact sensor connector (A).
4.
Install the air duct. [Left side only]
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
    Front Impact Sensor (FIS). Removal
       • Removal of the airbag must be performed according to the precautions / procedures de ...

    Side Impact Sensor (SIS). Description
    Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

    See also:

    Closing the tailgate
    To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING Make sure your hands, feet and other parts of your body are safely out ...

    Rear camera display (if equipped)
    The rear camera display will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that helps the ...

    Winter driving
    Severe weather conditions in the winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: ...