Kia Soul: ESC Control Module. Installation
Kia Soul 2014-2019 PS Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module. Installation
1. |
Install in the reverse order of removal.
|
2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
3. |
After installation, bleed the brake system.
(Refer to ABS bleeding)
|
4. |
When you have replaced the HECU always perform variant coding.
|
Variant coding
1. |
Connect the GDS to the data link connector.
|
2. |
Turn the ignition "ON".
|
3. |
Select vehicle name and system.
|
4. |
Select the variant coding.
|
5. |
Perform variant coding according to the instructions on the screen.
|
6. |
Ignition "OFF" and then ignition "ON".
|
7. |
The variant coding is completed.
|
ESC Control Module. Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the ECM. (Refer to Engine Control / Fuel Syst ...Front Wheel Speed Sensor. Components
1. Front wheel speed sensor 2. Front wheel speed sensor connector ...See also:
7,500 miles or 6 months
❑ Inspect air cleaner filter
❑ Inspect air conditioning compressor, air conditioner refrigerant and performance
(if equipped)
❑ Inspect cooling system *1
❑ Inspect dri ...
SS-B Solenoid Valve(ON/OFF). Circuit Diagram
...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the engineroom under cover.
3 ...