| •
|
Prolonged and repeated contact with mineral oil will result
in the removal of natural fats from the skin, leading to dryness,
irritation and dermatitis. In addition, used engine oil contains
potentially harmful contaminants which may cause skin cancer.
|
| •
|
Exercise caution in order to minimize the length and frequency
of contact of your skin to used oil. Wear protective clothing
and gloves. Wash your skin thoroughly with soap and water, or
use water-less hand cleaner, to remove any used engine oil.
Do not use gasoline, thinners, or solvents.
|
| •
|
In order to preserve the environment, used oil and used
oil filter must be disposed of only at designated disposal sites.
|
|
|
1. |
Drain engine oil.
|
(1) |
Remove the oil filler cap (A).
[Nu 2.0 GDI]
[Gamma 1.6 GDI]
|
|
(2) |
After lifting the car, remove the oil drain plug (A) and
drain oil into a container.
[Nu 2.0 GDI]
[Gamma 1.6 GDI]
|
|
|
2. |
Replace the oil filter.
|
(1) |
Remove the oil filter cap (A).
|
|
(2) |
Using the SST (09263-2E000), remove the oil filter (A).
|
|
(3) |
Check and clean the oil filter installation surface.
|
|
(4) |
Check the part number of the new oil filter is as same
as old one.
|
|
(5) |
Apply clean engine oil to the gasket of a new oil filter.
|
|
(6) |
Lightly screw the oil filter into place, and tighten it
until the gasket contacts the seat.
|
|
(7) |
Tighten it with the torque below.
Tightening torque :
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
|
[Nu 2.0 GDI]
[Gamma 1.6 GDI]
|
|
|
3. |
Install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.5 lb-ft)
|
|
|
4. |
Fill with new engine oil, after removing the engine oil level
gauge.
Capacity
[Nu 2.0 GDI]
Total: 4.5 L (1.19 U.S.gal., 4.76 U.S.qt., 3.96 lmp.qt.)
Oil pan: 3.7 L (0.98 U.S.gal., 3.91 U.S.qt., 3.26 lmp.qt.)
Drain and refill including oil filter:
4.0 L (1.06 U.S.gal., 4.23 U.S.qt., 3.52 lmp.qt.)
[Gamma 1.6 GDI]
Total : 3.7 ~ 4.0L (0.98 ~ 1.06 U.S.gal, 3.91 ~ 4.22U.S.qt.,
3.25 ~ 3.51lmp.qt.)
Oil pan : 3.3 L (0.87 U.S.gal., 3.48 U.S.qt., 2.90 lmp.qt.)
Drain and refill in cluding oil filter :
3.6 L (0.95 U.S.gal., 3.80 U.S.qt., 3.16 lmp.qt.)
|
|
|
5. |
Install the oil filler cap.
|
|
6. |
Start engine and check for oil leaks and check the oil gauge or
light for an indication of oil pressure.
|
|
7. |
Recheck the engine oil level.
|
Engine Oil Level
Be sure the vehicle is on level ground.
1.
Warm up and stop the engine, ...
1.
Visually check the pipes, hangers and connections for severe corrosion,
leaks or damage.
2.
Check for unusal exhaust sounds or abnormal ...
See also:
Components
1. Front pillar trim
2. Cowl side trim
3. Center pillar lower trim
4. Center pillar upper trim
5. Rear pillar trim
6. Front door scuff trim
7. Rear door scuff trim
...
Power Door Mirror Actuator Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door quadrant cover (A).
...
SRS Control Module (SRSCM). Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding”
procedure.
1.
...
Kia Soul: Engine oil and filter Replacement
Engine oil and filter Inspection
Exhaust System Inspection