Kia Soul: Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Remove the ECTS (Refer to "Removal").
|
3. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 1 and 3.
|
4. |
Check that the resistance is within the specification.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the engine coolant temperature sensor connector (A).
|
3. |
Disconnect the ignition coil connector (A) and CMPS connector
(B).
|
4. |
Unfasten the harness bracket (C) and Make a gap for removing high
pressure fuel pipe by moving the bracket (C).
|
5. |
Remove the vacuum pipe mounting bolts (A).
|
6. |
Remove the engine coolant temperature sensor (B).
|
7. |
Fill with engine coolant.
(Refer to Engine Mechanical System -"Coolant")
|
Installation
|
|
|
1. |
Install in the reverse order of removal.
|
Engine Coolant Temperature Sensor (ECTS). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...See also:
Installation
1.
Install in the reverse order of removal.
(1)
Tighten the nut with the specified torque.
Tightening ...
Seat belts - Front passenger and rear seat 3-point system with combination locking
retractor
To fasten your seat belt:
Combination retractor type seat belts are installed in the rear seat positions
to help accommodate the installation of child restraint systems. Although a combination
re ...
Manual transaxle oil Inspection
Oil level check
1.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
...