Kia Soul: Engine And Transmission Assembly Installation
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine And Transmission Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
• |
Adjust a shift cable.
|
• |
Adjust the throttle cable.
|
• |
Refill engine with engine oil.
|
• |
Refill a transaxle with fluid.
|
• |
Refill power steering fluid.
|
• |
Refill a radiator and a reservoir tank with engine coolant.
|
• |
Place a heater control knob on "HOT" position.
|
• |
Clean battery posts and cable terminals and assemble.
|
• |
Inspect for fuel leakage.
|
- |
After assemble the fuel line, turn on the ignition switch (do
not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
- |
Repeat this operation two or three times, then check for fuel
leakage at any point in the fuel line.
|
• |
Bleed air from the cooling system.
|
- |
Start engine and let it run until it warms up. (until the radiator
fan operates 3 or 4 times.)
|
- |
Turn Off the engine. Check the level in the radiator, add coolant
if needed. This will allow trapped air to be removed from the cooling
system.
|
Engine And Transmission Assembly Removal
• Use fender covers to avoid damaging painted surfaces. â ...See also:
Bluetooth® Wireless Technology(if equipped)
Bluetooth® Wireless Technology
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth
SIG, lnc. and any use of such marks by Kia is under license.
A Bluetooth® enabled ...
Component Location Index
Engine Room
[Gamma Engine]
1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Asse ...
Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
Circuit Diagram (3)
SRSCM Connector Terminal
Harness Connector
Pin No.
Function(connector
A)
Pin No.
...