Kia Soul: Drive Belt Adjustment - Timing System - Engine Mechanical SystemKia Soul: Drive Belt Adjustment

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Timing System / Drive Belt Adjustment

Drive belt tension measurement and adjustment
Belt tension measurement
Measure the belt tension using a mechanical tension gauge or a sonic tension meter.

Tension
New belt: 686.5 ~ 784.5N (70 ~ 80kg, 154.3 ~ 176.4lb)
Used belt: 490.3 ~ 588.4N (50 ~ 60kg, 110.2 ~ 132.3lb)

  
•
If the engine has run for 5 minutes or more, the belt tension must be adjusted as a used belt.
•
When installing the V-ribbed belt, all grooves on the pulley should be covered with belt ribs.
•
A loose belt causes slip noise.
•
Too tight belt cause bearing of alternator and water pump to damage.
Using a mechanical tension gauge
1.
While pressing the handle (A) of the gauge, insert the belt (B) between pulley and pulley (or idler) into the gap between spindle (C) and hook (D).

2.
After releasing the handle (A), read a value on the dial pointed by the indicator (B).

Using a sonic tension meter
1.
Input the belt specifications into the tension meter.
Belt type
Location of measurement
Input data
M (Mass, g/m.rib)
W (Width, rib)
S (Span, mm)
With A/C
Crankshaft pulley to A/C compressor pulley
13.4
6
178.9
Without A/C
Idler to alternator pulley
13.4
6
Actual measurement value

  
Measurement of S (Span) : Caculate average value after measuring the distance 3~4 times.

D : Idlerd
d : Alternator pulley

2.
Locate the micro phone (B) close to the center of belt span (A) and bounce the belt by finger 2~3 times. Read a value on the display.
[With A/C]

[Without A/C]

If adjustment is necessary:
1.
Loosen the mounting bolts (A).
2.
Tighten the adjusting bolt(B) clockwise in loose tension ; loosen the bolt counterclockwise in high tension.

3.
Recheck tension of the belt.
4.
After adjusting tension, tighten the through bolts.

Tightening torque
12mm (0.47in) bolt :
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 Ib-ft)
14mm (0.55in) bolt :
29.4 ~ 41.2 N.m (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

    Drive Belt Inspection
    Drive Belt Inspection Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt.    ...

    Drive Belt Installation
    1. Install the drive belt (A). 2. Adjust tension by tightening the alternator tension adjust bolt (B) and then install the mounting ...

    See also:

    Purge Control Solenoid Valve (PCSV). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Parking brake
    Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alon ...

    Knock Sensor (KS). Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...