Kia Soul: Delivery Pipe. Repair procedures - Fuel Delivery System - Engine Control / Fuel SystemKia Soul: Delivery Pipe. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Fuel Delivery System / Delivery Pipe. Repair procedures

Removal

  
 
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.  
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
  
 
When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3. Disconnect the injector & RPS extension connector (A).

4. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")
5. Remove the drive belt. (Refer to Engine Mechanical System - "Drive Belt")
6. Disconnect the alternator connector (A) and OCV connector (B)
7. Make a gap between the alernator (C) and the eninge assembly by pulling the alternator in the direction of arrow.

8. Remove the injector foam (A).

9. Remove the high pressure fuel pipe (A) after loosen the flang nuts (B) and mounting bolt (C).
High pressure fuel pipe flang nut: 26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft) High pressure fuel pipe function block mounting bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10. Remove the mounting bolts (A), and then remove the delivery pipe & injector assembly from the engine.
Delivery pipe mounting bolt : 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

11. Disconnect the injector connector (A)

12. Remove the fixing clip (A), and then and then separate the injector (B) from the delivery pipe.

Installation

  
 
Do not use already used injector fixing clip again.
  
 
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
  
 
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  
 
Apply engine oil to the injector O-ring.
Do not use already used injector O-ring again.
  
 
Do not use already used bolt again.
  
 
When insert the injector, be careful not to damage the injector tip.
1. Install in the reverse order of removal.
    Accelerator Pedal. Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. ...

    See also:

    Antenna Inspection
    Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. ...

    User Settings Mode
    Description On this mode, you can change setting of the doors, lamps, and so on. Door Auto Door Lock (if equipped) • Off: The auto door lock operation will be deactivated. & ...

    Flex steer
    The FLEX STEER controls steering effort based upon as driver's preference or road condition. You can select the desired steering mode by pressing the FLEX STEER button. When the steering mode b ...