Inspection
|
1. |
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
|
|
Removal
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
|
2. |
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
|
3. |
Disconnect the crankshaft position sensor connector (A) and remove
the sensor (B) after removing the installation bolt.
|
Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Crankshaft position sensor installation
bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Circuit Diagram
(M/T)
(A/T)
...
Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the ...
See also:
Interior
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Interior B
* These dimensions indicated in this f ...
Repeat
Press the
key
Set [
RPT] through the
TUNE knob or
key to repeat the current song.
❈ Press RPT again to turn off. ...
150,000 miles or 120 months
❑ Inspect air conditioning compressor, air conditioner refrigerant and performance
(if equipped)
❑ Inspect cooling system *1
❑ Inspect drive belt *4 (First 60,000 miles or 72 ...
Kia Soul: Crankshaft Position Sensor (CKPS). Repair procedures
Crankshaft Position Sensor (CKPS). Schematic Diagrams
Camshaft Position Sensor (CMPS). Description and Operation