Kia Soul: Compressor Inspection - Air conditioning System - Heating,Ventilation And Air ConditioningKia Soul: Compressor Inspection

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor Inspection

1.
Check the plated parts of the limiter & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the assembly.
2.
Check the pulley (B) bearing play and drag by rotating the pulley by hand. Replace the pulley with a new one if it is noisy or has excessive play/drag.

External Control Valve Compressor Inspection (GDS)
Compressor type: Fixed type compressor, External control valve, Internal control valve.
In cases of fixed type and internal control valve, it is possible to inspect compressor's operation with clutch noise.
When it comes to External control valve, however, it cannot be checked in this way bacause it doesn't have a clutch.
So, ECV should be inspected with GDS as below.
1.
Connect GDS to the vehicle and select 'Aircon Compressor Test(ECV type)'
[ECV1]

2.
Make the vehicle ready as the GDS instruction on the monitor. (Turn off A/C 'switch' only)
[ECV2]

[ECV3]

3.
Check if other DTC codes are found before inspect ECV compressor. If so, solve that problems first. If not, press 'OK' button to continue.
  
Do not continue inspection if these DTC codes are found: B1241, B1242, B1672, B1685, B1686, B1687
[ECV4]

4.
Start inspection
[ECV5]

[ECV6]

  
Check if condenser fan is operating when condition is changed to 'ECV running'
  
Relife valve will be operated if a condenser fan doesn't work because of overpressure in the compressor. It helps the airconditiong system to relieve by releasing refrigerant and oil. (Closed if relieved)
※ Refill refrigerant and oil after operation of Relife valve
※ Noise occurred when Relife vlave is in operation
5.
Check the result of inspection.
[ECV7]

[ECV8]

6.
If the result shows "Check" , click "Check" and follow the instruction.

7.
Inspect ECV again from the first step.
    Compressor Installation
    1. Make sure the compressor (A) mounting bolt with the correct length is screwed in. Tighten the mounting bolts with the specified tightening order. ...

    Compressor Disassembly
    1. Remove the front tire [RH]. 2. Loosen the front wheel guard mounting clips. 3. Separate the front portion of ...

    See also:

    Identification Numbers
    Identification Number Description Vehicle Identification Number 1. World Manufacturer Identifier (WMI) - KNA : Passenger vehicle, MPV(Multipurpose Passen ...

    Steering Column and Shaft. Components
    1. Steering column assembly 2. Steering joint assembly ...

    Mood Lamp Circuit Diagram
    ...