Kia Soul: Brake Booster. Removal - Brake System - Brake SystemKia Soul: Brake Booster. Removal

Kia Soul 2014-2019 PS Service Manual / Brake System / Brake System / Brake Booster. Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Remove the master cylinder.
(Refer to Brake System - "Master cylinder")
4.
Disconnect the vacuum hose (A) from the brake booster.
5.
Disconnect the vacuum pressure sensor connector (A) from the brake booster.
6.
Remove the snap pin (A) and clevis pin (B).
7.
Remove the brake booster mounting nuts (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

8.
Remove the brake booster (A).
    Brake Booster Operating Test
    For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

    Brake Booster. Inspection
    1. Inspect the check valve in the vacuum hose.    Do not remove the check va ...

    See also:

    Torque Converter Control Solenoid Valve (T/CON_VFS). Circuit Diagram
    ...

    Front Disc Brake. Installation
    Brake caliper assembly 1. Install in the reverse order of removal. 2. Compress the piston into the caliper body using the SST (09581-11000). ...

    Component Location Index
    Engine Room [Gamma Engine] 1. Receiver-drier 2. Condenser 3. Ambient temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Asse ...