Kia Soul: Blower Motor Replacement - Blower - Heating,Ventilation And Air ConditioningKia Soul: Blower Motor Replacement

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Replacement

[Standard Type]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the driver's side shower duct (A) after loosening the screw.
4.
Lower the steering column after loosening the mounting bolts and nuts.
(Refer to Steering System - "Steering Column and Shaft")
5.
Disconnect the mode control actuator connector (A) and then remove the mounting clip (B).
6.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
7.
Remove the brake pedal.
(Refer to Brake System - "Brake Pedal")
8.
Disconnect the connector (A) and then remove the blower motor (B) after loosening the screws.
9.
Install in the reverse order of removal.
[Telemetics Unit (TMU) Type]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the driver's side shower duct (A) after loosening the screw.
4.
Lower the steering column after loosening the mounting bolts and nuts.
(Refer to Steering System - "Steering Column and Shaft")
5.
Remove the telemetics unit (TMU).
(Refer to Body Electrical System - “Telemetics Unit (TMU)”)
6.
Disconnect the mode control actuator connector (A) and then remove the mounting clip (B).
7.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
8.
Remove the brake pedal.
(Refer to Brake System - "Brake Pedal")
9.
Disconnect the connector (A) and then remove the blower motor (B) after loosening the screws.
10.
Install in the reverse order of removal.
    Blower Motor Inspection
    1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

    See also:

    Smooth cornering
    Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be ...

    Drive Belt Inspection
    Drive Belt Inspection Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt.    ...

    Economical operation
    Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive. Each of these factors affects how many miles (kilometers) you can get from a gallon (l ...