Kia Soul: Airbag Module Disposal
Special tool required |
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those in a whole
vehicle to be scrapped), the airbags or side airbags must be deployed. If the
vehicle is still within the warranty period, before deploying the airbags or
side airbags, the Technical Manager must give approval and/or special instruction.
Only after the airbags or side airbags have been deployed (as the result of
vehicle collision, for example), can they be scrapped. If the airbags or side
airbags appear intact (not deployed), treat them with extreme caution. Follow
this procedure.
Deploying airbags in the vehicle
If an SRS equipped vehicle is to be entirely scrapped, its airbags or
side airbags should be deployed while still in the vehicle. The airbags or side
airbags should not be considered as salvageable parts and should never be installed
in another vehicle.
1. |
Turn the ignition switch OFF, and disconnect the battery negative
cable and wait at least three minutes.
|
2. |
Confirm that each airbag or side airbag is securely mounted.
|
3. |
Confirm that the special tool is functioning properly by following
the check procedure.
|
4. |
Place the deployment tool at least thirty feet (10meters) away
from the airbag.
|
5. |
Connect a 12 volt battery to the tool.
|
6. |
Push the tool’s deployment switch. The airbag should deploy (deployment
is both highly audible and visible: a loud noise and rapid inflation
of the bag, followed by slow deflection)
|
7. |
Dispose of the complete airbag. No part of it can be reused. Place
it in a sturdy plastic bag and seal it securely.
|
Deploying the airbag out of the vehicle
If an intact airbag has been removed from a scrapped vehicle, or has been
found defective or damage during transit, storage or service, it should be deployed
as follows:
1. |
Confirm that the special is functioning properly by following
the check procedure on this page.
|
2. |
Position the airbag face up, outdoors on flat ground at least
thirty feet (10meters) from any obstacles or people.
|
Disposal Of Damaged Airbag
1. |
If installed in a vehicle, follow the removal procedure of driver’s
airbag front passenger’s and side airbag.
|
2. |
In all cases, make a short circuit by twisting together the two
airbag inflator wires.
|
3. |
Package the airbag in exactly the same packing that the new replacement
part come in.
|
Curtain Airbag (CAB) Module. Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...See also:
Speed sensing door lock system (if equipped)
All doors will be automatically locked after the vehicle speed exceeds 9.3 mph
(15 km/h). And all doors will be automatically unlocked when you turn the engine
off or when you remove the ignition ...
Air intake control
This is used to select outside (fresh) air position or recirculated air position.
To change the air intake control position, push the control button.
Recirculated air position
The indicator lig ...
Front Disc Brake. Inspection
Front brake disc thickness check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...