Kia Soul: Accelerator Position Sensor (APS). Repair procedures
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Repair procedures
Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Turn the ignition switch ON.
|
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
terminal.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the mounting nuts (B).
|
4. |
Remove the cap (A)
|
5. |
Remove the mounting bolt (A), and then remove the accelerator
pedal module.
|
Installation
1. |
Install in the reverse order of removal.
|
Accelerator Position Sensor (APS). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...See also:
Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500
miles (12,000 km) or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When r ...
Display Settings
Press the
key
Select [Display] through
TUNE knob or key
Select menu through
TUNE knob
...
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...