Kia Soul: Wheel. Hub nut tightening sequence - Tires/Wheels - Suspension SystemKia Soul: Wheel. Hub nut tightening sequence

Kia Soul 2014-2019 PS Service Manual / Suspension System / Tires/Wheels / Wheel. Hub nut tightening sequence

Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

  
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Run-out
 Aluminum
 Steel
Radial mm(in.)
 Below 0.3(0.0118)
 Below 1.4(0.0551)
Lateral mm(in.)
 Below 0.3(0.0118)
 Below 0.9(0.0354)

3.
If measured value exceeds the standard value, replace the wheel.
    Tire Installation
    1. Apply tire soap or lubrication to the top and bottom tire beads. 2. To fit the bottom bead, position the valve at the 5 o’clock pos ...

    Alignment. Front wheel alignment
       When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always ...

    See also:

    Checking the amount of air conditioner refrigerant and compressor lubricant
    When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative impact on the air conditioning system. Therefore, if abnormal operation is ...

    Occupant Detection System (ODS)
    Your vehicle is equipped with an occupant detection system in the front passenger's seat. The occupant detection system is designed to detect the presence of a properly-seated front passe ...

    Cooling Fan Inspection
    Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...