Kia Soul: Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Variable Intake Solenoid (VIS) Valve. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.
Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector (A).
3.
Disconnect the vacuum hoses (B) from the valve.
4.
Remove the valve (C) from the surge tank.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.
    Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Fuel Pressure Control Valve. Description and Operation
    Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

    See also:

    Component Location
    1. Head lamp (Low) 2. Head lamp (High) 3. Head lamp (Low/ High) 4. Turn signal lamp 5. Side marker 6. DRL & Position lamp 7. Front fog lamp 8. ...

    Intake Air Temperature Sensor (IATS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Cylinder Head Cover Installation
    1. Install the cylinder head cover (A) with a new gasket (B).    Do ...