Kia Soul: Using Voice Recognition - Voice recognition - Features of your vehicleKia Soul: Using Voice Recognition

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Voice recognition / Using Voice Recognition

Starting Voice Recognition

Shortly press the key on the steering wheel. Say a command key on the steering wheel. Say a command

If prompt feedback is in [ON], then the system will say “Please say a command

If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)”

  • If prompt feedback is in [OFF] mode, then the system will only say “(BEEP)”
  • To change Prompt Feedback [On]/[Off], go to  [System] [System] [Prompt Feedback] [Prompt Feedback]
  • For proper recognition, say the command after the voice instruction and beep tone.

Skipping Prompt Messages

While prompt message is being stated Shortly press the Shortly press the key on the steering remote controller key on the steering remote controller

The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.

Re-starting Voice Recognition

While system waits for a command Shortly press the Shortly press the key on the steering remote controller key on the steering remote controller

The command wait state is immediately ended and the beep ton will sound. After the “beep”, say the voice command.

    Voice recognition
    ...

    Ending voice recognition
    While Voice Recognition is operating Press and hold the key on the steering remote controller While using voice command, pressing any steering wheel control or a different key will end vo ...

    See also:

    Owner maintenance
    The following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation of you ...

    Tire Installation
    1. Apply tire soap or lubrication to the top and bottom tire beads. 2. To fit the bottom bead, position the valve at the 5 o’clock pos ...

    CVVT & Camshaft Inspection
    Camshaft 1. Measure the height of the cam lobe using a micrometer and check the surface of the cam lob for wear and tear. If necessary, replace the camshaft. ...