Kia Soul: Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating.
They will self-cancel after a turn is completed. If the indicator continues to flash after a turn, manually return the lever to the OFF position.
To signal a lane change, move the turn signal lever slightly and hold it in position (B). The lever will return to the OFF position when released.
If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement.
If an indicator flash is abnormally quick or slow, a bulb may be burned out or have a poor electrical connection in the circuit.
One-touch lane change function
To activate an one-touch lane change function, move the turn signal lever slightly and then release it.
The lane change signals will blink 3, 5 or 7 times.
✽ NOTICE
If an indicator flash is abnormally quick or slow, the bulb may be burned out or have a poor electrical connection in the circuit.
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will light when the headlight high beams are switched
on.
To prevent th ...
Front fog light (if equipped)
Fog lights are used to provide improved visibility when visibility is poor due
to fog, rain or snow, etc. The fog lights will turn on when the fog light switch
(1) is turned to the on position ...
See also:
Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between
the front (A) and rear (B) glass and if needed adjust it.
...
Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge ...
Crankshaft Inspection
1.
Check the crankshaft main bearing oil clearance.
(1)
To check main bearing-to-journal oil clearance, remove
the bearing caps with ...