1. |
General Function
A. |
Auto-learn takes place only once per Ignition cycle.
|
B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
2. |
General Conditions to Learn New Sensors:
A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
2) |
Uses confidence reduction of previously learned
sensors.
|
|
B. |
Typical time at driving continuously over 15.5 mph(25
kph) to learn a new sensor is up to 20 minutes.
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
A. |
It takes less than 20 minutes at 15.5 mph(25 mph).
|
B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Components Location
1. Oil filler plug
2. Oil drain plug
...
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance. Keep receipts for all vehicle emission services to protect
your warranty. Where both mileage a ...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp
or wiper switch.
...