Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
•
|
Do not open the lid of the side airbag cover.
|
•
|
Make sure that the airbag assembly cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install in the reverse order of removal.
|
4. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
5. |
Reconnect the battery negative cable.
|
6. |
After installing the side airbag (SAB), confirm proper system
operation:
A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain airbag by us ...
See also:
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)
...
Description
-
Ignition lock switch is mounted on the clutch pedal.
-
Ignition lock switch is operated when you press the clutch pedal.
-
...
Vehicle data collection and event data recorders
This vehicle is equipped with an event data recorder (EDR). The main purpose
of an EDR is to record, in certain crash or near crash-like situations, such as
an air bag deployment or hitting a road ...