Kia Soul: Seat Belt Buckle Switch (BS). Description - SRSCM - RestraintKia Soul: Seat Belt Buckle Switch (BS). Description

Kia Soul 2014-2019 PS Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS). Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will be deactivated.
    Side Impact Sensor (SIS). Installation
    Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) and then connect the pressure side impact sensor connector (A). ...

    See also:

    Vehicle weight
    This section will guide you in the proper loading of your vehicle and/or trailer, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loadin ...

    Intake Actuator Description
    The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fr ...

    Rear Wheel Speed Sensor Repair procedures
    Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor. (Refer to Driveshaft and ...