Kia Soul: Roof Rack Replacement - Body Side Moulding - Body (Interior and Exterior)Kia Soul: Roof Rack Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Body Side Moulding / Roof Rack Replacement

[Panorama Sunroof Type]
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the roof rack front cover (A) and roof rack rear cover (B).
2.
Remove the roof rack side rail cap (C).
3.
After loosening the mounting nuts, then remove the roof rack assembly (D).

Tightening torque :
3.9 ~ 4.4 N.m ( 0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft )

4.
Using a screwdriver or remover, remove the rear roof garnish (E).
5.
Install in the reverse order of removal.
  
Replace any damaged clips.

1. Roof rack front cover
2. Roof rack rear cover
3. Roof rack side rail cap
4. Roof rack assembly
5. Rear roof garnish

[Normal Roof Type]
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the roof rack front cover (A) and roof rack rear cover (B).
2.
Remove the roof rack side rail cap (C).
3.
After loosening the mounting nuts, then remove the roof rack assembly (D).

Tightening torque :
3.9 ~ 4.4 N.m ( 0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft )

4.
Using a screwdriver or remover, remove the rear roof garnish (E).
5.
Using a screwdriver or remover, remove the front roof garnish (F).
6.
Install in the reverse order of removal.
  
Replace any damaged clips.

1. Roof rack front cover
2. Roof rack rear cover
3. Roof rack side rail cap
4. Roof rack assembly
5. Rear roof garnish
6. Front roof garnish

    Roof Side Moulding Replacement
       • Put on gloves to protect your hands. ...

    See also:

    Input Speed Sensor. Circuit Diagram
    ...

    Inspection (With GDS)
    1. Check IPM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. ...

    High Voltage Battery Heater Relay Repair procedures
    Inspection     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failur ...