Kia Soul: Replacement - Fuel Filler Door - Body (Interior and Exterior)Kia Soul: Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Fuel Filler Door / Replacement

[Fuel Filler Door]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
1.
Open the fuel filler door.
2.
After loosening the mounting bolts (A), then remove the fuel filler door (B).
3.
Install in the reverse order of removal.
  
•
Make sure the fuel filler door locks/unlocks and opens/closes properly.
[Fuel Filler Door Catch & Cable]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
4.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
5.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
6.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
7.
Loosen the fuel filler door lever mounting bolt (A).
8.
Using a clip remover, remove the fuel filler door catch (B).
9.
Remove the fuel filler door cable (C).
10.
Install in the reverse order of removal.
  
•
Make sure the fuel filler door locks/unlocks and opens/closes properly.
    Component Location
    1. Fuel filler door ...

    Hood
    ...

    See also:

    Air Conditioning refrigerant label
    Each symbols and specification on air conditioning refrigerant label means as below ; 1. Classification of refrigerant 2. Amount of refrigerant 3. Classification of Compressor lubricant ...

    Blower Unit Components
    1. Intake case [LH] 2. Intake seal 3. Intake case [RH] 4. Tap screw ratchet 5. Intake actuator 6. Air filter 7. Filter cover assembly 8. Intake door assembly 9. ...

    Head Lamp Leveling Actuator Inspection with GDS
    Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No. Procedure 1 Loc ...