Kia Soul: Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the audio/ AVN head unit assembly.
(Refer to Body Electrical System - "Audio Unit")
(Refer to Body Electrical System - "AVN Head Unit")
|
3. |
Remove the glove box housing assembly.
(Refer to Body - "Glove Box Housing")
|
4. |
Separate the wiring fixed clip (A) on the BCM bracket.
|
5. |
Loosen the mounting nuts from the BCM unit.
|
6. |
Disconnect the connectors from the BCM (in the order as below)
|
Circuit Diagram
...
Installation
1.
Connect the connectors and install the BCM.
2.
Install the glove box housing and audio/AVN head unit.
...
See also:
Flex steer
The FLEX STEER controls steering effort based upon as driver's preference or road condition.
You can select the desired steering mode by pressing the FLEX STEER button.
When the steering mode b ...
35R Clutch Control Solenoid Valve(35R/C_VFS). Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Rear Torsion Beam Axle Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...