Kia Soul: Rear Wiper Motor Installation - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Wiper Motor Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Installation

1.
Install the rear wiper motor assembly.

Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)

2.
Install the tailgate trim.
3.
Install the rear wiper arm cap after tighting the nut.

Tightening torque Nut :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)

4.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position

    Rear Wiper Motor Removal
    1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut ...

    Rear Washer Switch Inspection
    1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. ...

    See also:

    Tire chains
    Tire chains, if necessary, should be installed on the front wheels. Be sure that the chains are installed in accordance with the manufacturer's instructions. To minimize tire and chain wear, do ...

    How does the air bag system operate
    Air bags are activated (able to inflate if necessary) only when the ignition switch is turned to the ON or START position. The appropriate air bags inflate instantly in the event of a serious ...

    Compession Pressure Inspection
       If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. ...