Kia Soul: Rear Wiper Motor Inspection - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Wiper Motor Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Inspection

Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No.
Description
1
Battery (+)
2
Parking
3
Ground
4
Signal

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
3.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.
4.
Check that the motor stops running at the off position.

    Component Location
    1. Head cap 2. Rear wiper arm nut 3. Rear wiper arm & blade 4. Grommet 5. Rear wiper motor assembly 6. Rear wiper motor bolt ...

    Rear Wiper Motor Removal
    1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut ...

    See also:

    Component Location
    1. Drive power window switch 2. Passenge power window switch 3. Front window motor 4. Rear window motor 5. Rear window switch ...

    Side Impact Sensor (SIS). Description
    Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

    Evaporator Temperature Sensor Description
    The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...