Kia Soul: Rear Seat Cushion Cover Replacement - Rear Seat - Body (Interior and Exterior)Kia Soul: Rear Seat Cushion Cover Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen the heater ECU unit mounting screws (A).
3.
Disconnect the heater ECU unit connector (B) and then remove the mounting clips (C).
[LH]

[RH]
4.
After removing the hog-ring clips (A) on the rear of seat cushion and remove the rear seat cushion cover (B).
[Rear side]

[Front side]
5.
Install in the reverse order of removal.
  
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Rear Seat Cushion Cover Component Location
    1. Rear seat cushion cover ...

    Rear Back Armrest Component Location
    1. Rear back armrest ...

    See also:

    Alternator Removal
    1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

    Cylinder Head Inspection
    Cylinder Head 1. Inspect for flatness. Using a precision straight edge and filler gauge, measure the surface the contacting the cylinder block and the ...

    Center Fascia Panel Replacement
       • Put on gloves to protect your hands. ...