Kia Soul: Rear Back Armrest Replacement - Rear Seat - Body (Interior and Exterior)Kia Soul: Rear Back Armrest Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Replacement

  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the lock hook (B) and then remove the rear seat armrest (A).
2.
Press the rear seat armrest (A) in the direction of the arrow in the below picture, and then remove it by pulling it up.

  
Rear seat armrest installment
(1)
Install the cap (A) on the side part of the armrest.
[LH]

[RH]

(2)
Put the left side part (A) of the armrest into the hole (B).

(3)
Push the armrest (A) sidewards in the direction of the arrow, and then install it.

    Rear Back Armrest Component Location
    1. Rear back armrest ...

    Rear Seat Latch Component Location
    1. Rear seat latch assembly ...

    See also:

    Purge Control Solenoid Valve (PCSV). Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between th ...

    Fuel Tank Pressure Sensor (FTPS). Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...

    Emergency starting
    Connect cables in numerical order and disconnect in reverse order. ...