Kia Soul: Power windows - Windows - Features of your vehicleKia Soul: Power windows

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Windows / Power windows

The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window.

The driver has a power window lock button which can block the operation of the rear passenger windows. The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position.

However, if the front doors are opened, the power windows cannot be operated even within the 30 second period.

✽ NOTICE

While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open) position, your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

Window opening and closing

The driver’s door has a master power window switch that controls all the windows

The driver’s door has a master power window switch that controls all the windows in the vehicle.

To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5).

Auto down window (if equipped)

Pressing the power window switch momentarily to the second detent position (6)

Pressing the power window switch momentarily to the second detent position (6) completely lowers the driver’s window even when the switch is released. To stop the window at the desired position while the window is in operation, momentarily pull up the switch to the opposite direction of the window movement.

Auto up/down window (if equipped)

Pressing or pulling up the power window switch momentarily to the second detent

Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or raises the window even when the switch is released. To stop the window at the desired position while the window is in operation, pull up or press down and release the switch.

If the power window does not operate normally, the automatic power window system must be reset as follows:

1. Turn the ignition switch to the ON position.

2. Close the driver’s window and continue pulling up the driver’s power window switch for at least 1 second after the window is completely closed.

    Windows
    (1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening a ...

    Automatic reversal
    If the upward movement of the window is blocked by an object or part of the body, the window will detect the resistance and will stop upward movement. The window will then lower approximately ...

    See also:

    Tire chains
    Tire chains, if necessary, should be installed on the front wheels. Be sure that the chains are installed in accordance with the manufacturer's instructions. To minimize tire and chain wear, do ...

    Inspection
    Signal Circuit Inspection 1. Check clutch switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". ...

    Copy
    Press the key Set [ Copy] through the TUNE knob or key. This is used to copy the current song into My Music. You can play the copied Music in My Music mode. ❈ If another k ...