Kia Soul: Photo Sensor Inspection - Air conditioning System - Heating,Ventilation And Air ConditioningKia Soul: Photo Sensor Inspection

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Photo Sensor Inspection

1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and reduce with lower intensive light.

1. Auto light signal
2. Auto light ground
3. Photo signal (RH)
4. LED power (B+)
5. LED ground (To BCM)
6. Photo signal (LH)
7. Photo power
8. Auto light power (5V)

    Photo Sensor Description
    The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving ...

    Photo Sensor Replacement
    1. Disconnect the negative (-) battery terminal. 2. With a flat-head screwdriver, remove the photo sensor (A) from the center of the defros ...

    See also:

    Runaway Arresting Device (RAD) Description and Operation
    Description RAD is installed on each battery module. If the high voltage battery is swollen by cell overcharge, RAD cuts the ground of the main relay and the pre-charge relay. If the cell is ove ...

    Rear Seat Belt Retractor Repair procedures
    Replacement     • When installing the belt, be careful not to damage the retractor. 1. Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar ...

    Mode Control Actuator Replacement
    [Standard Tyep] 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash P ...