Kia Soul: Oil Pressure Switch - Lubrication System - Engine Mechanical SystemKia Soul: Oil Pressure Switch

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch

1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.

2.
Check the continuity between the terminal and the body when the fine wire is pushed.
If there is continuity even when the fine wire is pushed, replace the switch.

3.
If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
    Oil Pressure Switch Removal and Installation
    1. Remove the under cover. 2. Remove the oil drain plug, and drain the oil into a container. 3. Remove the ...

    Oil Pan Components
    1. Gasket 2. Oil screen 3. Oil pan 4. Drain plug gasket 5. Drain plug ...

    See also:

    A/C Pressure Transducer Repair procedures
    Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminals No. 1 and No. 2. 2. Inspect the voltage value whether it is within the specified range. ...

    Parking brake
    Applying the parking brake To engage the parking brake, first apply the foot brake and then pull up the parking brake lever as far as possible. In addition it is recommended that when parking th ...

    Troubleshooting
    Basic Troubleshooting Basic Inspection Procedure Measuring Condition of Electronic Parts'' Resistance The measured resistance at high temperature after vehicle running may be high or low. So al ...