Kia Soul: Normal maintenance schedule
The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty. Where both mileage and time are shown, the frequency of service is determined by whichever occurs first.
*1 lnspect "Water Pump" when replacing the drive belt or timing belt.
*2 Fuel filter & Fuel tank air filter are considered to be maintenance free but
periodic inspection is recommended for this maintenance schedule depends on fuel
quality. If there are some important safety matters like fuel flow restriction,
surging, loss of power, hard starting problem etc, replace the fuel filter immediately
regardless of maintenance schedule and consult an authorized Kia dealer for details.
*3 Inspect for excessive tappet noise and/or engine vibration and adjust if necessary.
*4 The drive belt should be replaced when cracks occur or tension is reduced excessively.
*5 When replacing coolant, use only a qualified coolant additive for your vehicle
and never mix hard water in the coolant filled at the factory. An improper coolant
mixture can result in serious malfunction or engine damage.
*6 If TOP TIER Detergent Gasoline is not available, one bottle of additive is recommended.
Additives are available from your authorized Kia dealer along with information on
how to use them. Do not mix other additives.
- 7,500 miles or 6 months
- 15,000 miles or 12 months
- 30,000 miles or 24 months
- 45,000 miles or 36 months
- 60,000 miles or 48 months
- 75,000 miles or 60 months
- 90,000 miles or 72 months
- 105,000 miles or 84 months
- 120,000 miles or 96 months
- 135,000 miles or 108 months
- 150,000 miles or 120 months
Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Sever ...7,500 miles or 6 months
❑ Inspect air cleaner filter ❑ Inspect air conditioning compressor, air conditioner refrigerant and performance (if equipped) ❑ Inspect cooling system *1 ❑ Inspect dri ...See also:
Seat Heater (Air Ventilation) Inspection
Front Seat
1.
Check for continuity and measure the resistance between terminals.
Connector
...
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be in
your vehicle and vehicle cap ...
Input Speed Sensor. Specifications
▷ Type: Hall effect sensor
Operation condition (°C)°F
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8) 0.0472 ~ 0.0709
Output voltage(V)
...