Kia Soul: Mode Control Actuator Replacement
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver's side shower duct (A) after loosening the screw.
|
4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver's side shower duct (A) after loosening the screw.
|
4. |
Lower the steering column after loosening the mounting bolts and
nuts.
(Refer to Steering System - "Steering Column and Shaft")
|
5. |
Remove the telemetics unit (TMU).
(Refer to Body Electrical System - “Telemetics Unit (TMU)”)
|
6. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
7. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
See also:
Non-operational conditions of Reverse Parking Distance Warning system
Reverse Parking Distance Warning system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered ...
Canister Close Valve (CCV). Description and Operation
Description
Canister Close Valve (CCV) is normally open and is installed on the canister
ventilation line. It seals evaporative emission control system by shutting the
canister from the atmo ...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The mea ...