Kia Soul: Installation - Seat Belt Pretensioner - RestraintKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / Seat Belt Pretensioner / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the seat belt pretensioner with bolt (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner connector (A).
5.
Install the front seat belt upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.
Install the center pillar upper trim.
(Refer to Body - "Center pillar trim")
7.
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
8.
Insert the seat belt to the emergency fastening device (A).

  
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Removal
    1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. To remove the emergency fastening ...

    Emergency Fastening Device (EFD). Description
    Emergency Fastening Device (EFD) is deployed with Belt Pretensioner at the same time to pull down the seat belt strongly If it gets into its deploy condition after a collision. It is located ...

    See also:

    Cluster Fascia Panel Replacement
       • Put on gloves to protect your hands. ...

    Precautions
    General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbag ...

    Crankshaft Position Sensor (CKPS). Specifications
    Specification Item Specification Coil Resistance (Ω) 774 ~ 946 [20°C (68°F)] ...