Kia Soul: Installation - Automatic Transaxle - Automatic Transaxle SystemKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle / Installation

1.
Install in the reverse order of removal.
  
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (oil seal installer, 09452-26100).
  
After replacement or reinstallation procedure of the automatic transaxle assembly, must perform procedures below.
•
Should be adding automatic transaxle fluid when reinstall the transaxle.
(Refer to Hydraulic System - "Fluid")
•
After replacing the automatic transaxle, clear the Diagnostic Trouble Code(DTC) using the GDS tool. DTC cannot be cleared by disconnecting the battery.
•
When replacing the automatic transaxle, reset the automatic transaxle's values by using the GDS.
55555

•
Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
    Removal
    1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and battery ...

    Clutch & Brake
    ...

    See also:

    Components and Components Location
    Components (1) (Rear Seat Back Assembly) 1. Rear seat headrest [LH] 2. Rear seat headrest [Center] 3. Rear seat headrest [RH] 4. Rear seat headrest guide [RH] 5. R ...

    Inhibitor Switch. Specifications
    ▷ Type: Combination of output signals from 4 terminals Power supply (V) 12 Output type Combination of output signals Signal Code Table ...

    Removal
    1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and battery ...