Kia Soul: Hands Free Switch Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the driver airbag module.
(Refer to the RT group)
|
3. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
4. |
Loosen the mounting screws from the rear steering wheel cover.
|
5. |
Separate the upper steering wheel remote control switch (A)
from the steering wheel.
[LH]
[RH]
|
6. |
Remove the upper steering wheel control switch (B) disconnecting
the connector (A).
[LH]
[RH]
|
7. |
Separate the lower steering wheel control switch (A) loosening
the mounting screws.
[LH]
|
8. |
Remove the lower steering wheel control switch (B) disconnecting
the connector (A).
[LH]
|
Hands Free Switch Inspection
1.
Check for resistance between terminals in each switch position.
[Voice + Bluetooth]
[Voice + Bluetooth]
Switch
...
Hands Free Switch Installation
1.
Install the remote control switch on the steering wheel.
2.
Install the steering wheel.
3.
...
See also:
BCW (Blind-Spot Collision Warning) (if equipped)
Operating conditions
The indicator on the switch will illuminate when the BCW button is pressed with
the engine start/stop button ON. If the vehicle speed exceeds 30 km/h (18.6 mph),
the system ...
Compressor Disassembly
1.
Remove the front tire [RH].
2.
Loosen the front wheel guard mounting clips.
3.
Separate the front portion of ...
Front Body
Front Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front Body B
* These dimensions indicated in th ...