•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the crash pad side cover
[RH] (A).
![](./images/books/1647/spsbd4679n.gif)
|
2. |
Loosen the glove box housing mounting bolts (A).
![](./images/books/1647/spsbd4680n.gif)
|
3. |
After loosening the mounting screws, then remove the glove box
housing (A) by using a screw driver.
![](./images/books/1647/spsbd4681n.gif)
|
4. |
Disconnect the glove box lamp connector (A).
![](./images/books/1647/spsbd4682n.gif)
|
5. |
Remove the glove box housing mounting clip (A).
![](./images/books/1647/spsbd4683n.gif)
• |
When installing glove box housing, be sure to
insert lock pin (A) into wiring tape (B).
|
|
![](./images/books/1647/spsbd4684n.gif)
|
6. |
Install in the reverse order of removal.
• |
Make sure the connector are connected in properly.
|
• |
Replace any damaged clips.
|
|
|
1. Steering column shroud lower panel
2. Steering column shroud upper panel
...