Kia Soul: Fuel Tank Pressure Sensor (FTPS). Repair procedures
Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the FTPS.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the rear seat cushion.
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel tank pressure sensor connector (A).
|
5. |
Remove the fuel tank pressure sensor (B) after releasing the hooks
vertically.
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Injector. Description and Operation
Description
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling a ...
See also:
Side repeater light bulb Type A replacement (if equipped)
1. Remove the light assembly from the vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens parts by turning ...
Power windows
The ignition switch must be in the ON position for power windows to operate.
Each door has a power window switch that controls the door's window.
The driver has a power window lock button which ...
Tilting the sunroof
Before opening or closing the sunroof, open the sunshade (refer to the following
page for instructions on how to use the sunshade).
To tilt up the sunroof
- Push the sunroof glass control leve ...