Removal
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).

|
3. |
Remove the head assembly (A) after releasing the cushion fixing clip (B).

|
4. |
Disconnect the fuel tube connector (A).

|
5. |
Remove the reservior-cup (B) after releasing the fixing hooks (A).

|
6. |
Disconnect the fuel tube quick-connector (A).
|
7. |
Release the fixing hooks, and then remove the pre-filter (B).

|
8. |
Remove the fuel pressure regulator (A) and fuel pump motor (B).

|
Installation
1. |
Install in the reverse order of removal.
|
Inspection
[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
...
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
...
See also:
Replacement
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
Accelerator Position Sensor (APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important senso ...
Owner’s responsibility
✽ NOTICE
Maintenance Service and Record Retention are the owner's responsibility.
You should retain documents that show proper maintenance has been performed
on your vehicle in accordan ...