•
|
In order to remove the front glass, use the tools shown
in the following figure:
[Tooling Diagram]

Square wire
Insert-type wire grip
[Tooling Assembly Diagram]
|
|
1. |
Press panorama sunroof switch to fully open the movable glass.
|
2. |
Remove the roof side moulding.
(Refer to Body Side Moulding - "Roof Side Moulding")
|
3. |
Pull the square wire (A) to the left and right, then apply a force
in the direction of the arrow to cut off the residual sealant.
• |
Longer wires require more power, so divide Section
and
in half to cut off residual
sealant.
|
|
• |
Make sure that you put on gloves to protect your
hands from potential injury.
|
• |
Be careful about potentially burning your hands
due to the heat generated from the wire in use.
|
• |
Be careful when working with wiring because it
may be cut.
|
|
• |
Be careful not to damage the body.
|
|

|
4. |
Remove the front glass (A) carefully without damaging it.

|
1.
Completely open the movable glass using the panorama sunroof switch.
2.
Remove both sides of the decoration cover (A) by pulling it in
t ...
•
In order to mount the front glass, use the tools shown
in the following figure:
...
See also:
Air conditioning refrigerant label
Each symbols and specification on air conditioning refrigerant label means as
below ;
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of Compressor lubricant
You ca ...
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons
other than the AUTO button. In this case, the system works sequentially according
to the order of buttons selected.
Wh ...
Auto Head Lamp Leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Sensor angle change.
...