•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the mounting clips, and then remove the air duct (A).
|
2. |
Loosen the radiator upper cover mounting bolts and clips.
|
3. |
Loosen the front bumper lower mounting clips.
|
4. |
After loosening the front bumper side's mounting screw, then disconnect
the side's.
• |
Remove the front bumper by pulling up the side
of the front bumper and then pull it out.
|
|
• |
When you pull out the front bumper, the side part
of the front bumper could be damaged by the projection.
|
|
|
5. |
Disconnect the fog lamp connector (A) and front bumper main connector
(B).
[LH]
[RH]
|
6. |
Remove the front bumper cover.
(1) |
Lift up the lower side of the front bumper cover (A).
|
(2) |
Remove the front bumper cover (A) by pushing it rearward
to release the locking pins (B) located upper side of the front
bumper cover.
|
(3) |
Remove the front bumper cover (A).
|
|
7. |
Install in the reverse order of removal.
• |
Make sure the connector is plugged in properly.
|
• |
Replace any damaged clips.
|
|
|
1. Front bumper cover
...
See also:
Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2]
A/F Ra ...
Installation
1.
Install in the reverse order of removal.
(1)
Tighten the nut with the specified torque.
Tightening ...
Immobilizer system (if equipped)
Your vehicle is equipped with an electronic engine immobilizer system to reduce
the risk of unauthorized vehicle use.
Your immobilizer system is comprised of a small transponder in the ignition key ...