Kia Soul: Front Body
Front Body A
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
Front Body B
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
Front Body C
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
Front Body D
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Hood hinge mounting hole (Ø11) |
Fender apron upper panel tooling hole (Ø6.6) |
Fender apron upper panel tooling hole (Ø6.6) |
|
|
|
|
| Fender apron member tooling hole (Ø6) |
Front shock absorber mounting hole (Ø15) |
Cowl panel tooling hole (Ø6.6) |
|
|
|
|
| Side outer panel corner |
Side outer panel corner |
Engine mounting bracket hole (Ø12) |
|
|
|
|
| Transaxle mounting hole (Ø12) |
Engine mounting bracket hole (Ø12) |
Transaxle mounting hole (Ø13) |
|
|
|
|
| Front side member tooling hole (Ø8.8) |
Front side member tooling hole (Ø6.6) |
Front end module mounting hole (Ø11) |
Body Dimensions
...
Side Body
Side Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Side Body B
* These dimensions indicated in this ...
See also:
Alternator Specification
Alternator
ltem
Specification
Nominal output
13.5V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator bu ...
Blower Resistor (Manual) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Air Cleaner Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Remove the air duct and air cleane ...