Kia Soul: Engine And Transmission Assembly Installation
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine And Transmission Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Adjust a shift cable.
|
| • |
Adjust the throttle cable.
|
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill power steering fluid.
|
| • |
Refill a radiator and a reservoir tank with engine coolant.
|
| • |
Place a heater control knob on "HOT" position.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line, turn on the ignition switch (do
not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check for fuel
leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up. (until the radiator
fan operates 3 or 4 times.)
|
| - |
Turn Off the engine. Check the level in the radiator, add coolant
if needed. This will allow trapped air to be removed from the cooling
system.
|
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
â ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS). Removal
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...
Engine
...
Key operations
Type A
Type B
Used to start the engine.
Used to lock and unlock the doors.
Type B
To unfold the key, press the release button then the key will unfold automatically.
To fold the key, f ...