Kia Soul: Canister Close Valve (CCV). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Canister Close Valve (CCV). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV terminal 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.
Disconnect the vapor hose connected with the canister from the CCV.
6.
Connect a vacuum pump to the nipple.
7.
Ground the CCV control line and apply battery voltage to the CCV power supply line.
8.
Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the canister close valve.
5.
Remove the canister close valve (C) after removing the bolts.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.
    Canister Close Valve (CCV). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    See also:

    Heater Core Replacement
    1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

    Power Seat Motor Inspection
    Power Seat Motor 1. Disconnect the connectors for each motor. (Refer to Body - "Front Seat Assembly") A : Slide motor B : Fro ...

    Cylinder Head Disassembly
       Identify MLA(Mechanical lash adjuster), valves, valve springs as they are removed so that each item can be reinstalled i ...